Glock 19 Extended Slide Stop Lever Review

 

Glock 19 Extended Slide Stop Lever (On Right)
 Glock Extended Slide Release (Right)
Glock 19 Stock Slide Stop Lever (Left)

Laser Bullet for Gun Training

Great Deals On Handguns

Glock Accessories

Glock 19 Modifications

 

Glock 19 Extended Slide Stop Lever

The Glock Extended Slide Release installed on a Glock 19 really makes releasing the slide a breeze. It's over 3mm longer than the standard slide release but not large enough to snag on a holster of clothing.  With my hands, I thought I would never be able to release the slide one-handed. To my surprise and delight it was easy. The little extension really does make a big difference.

Recommendation: Get One!

 

Glock 19 Extended Slide Stop Lever Installation


 Glock Extended Slide Release
Glock:19/20SF/21SF/22/23/26/27/30SF/31-33/35

Step 1:
Remove the slide and the magazine from the pistol.

Step 2:
  1. Get a roll of tape to be used as a rest or holder.
  2. Place the receiver, left side up on the roll of tape.
 

Step 3:
Push out the roll pin on the side of the receiver. It's the bigger and lower one on the left side, just above the trigger (You don't have to use much force to remove the pin. The spring retains the pin so all you have to do is wiggle the slide stop with your right hand and push the pin in with your tool in the left hand.)

Step 4:
Observe the placement and position of the slide stop Lever. Look specifically at the location of the forward prong (spring) of the slide stop lever (the part with the hole in it).

Step 5:
Slowly pull out (back and upwards) the old Slide Stop Lever. While you are here you might as well clean the frame where the stop lever is installed with a Q-tip.

Step 6:
Compare the old Slide Stop Lever with the new one to make sure they are identical with the exception of the larger stop/grip.

Step 7:
  1. Install the new Extended Slide Stop Lever into the Glock. Push it forward until the pin hole lines up with the hole in the frame.
  2. Place the receiver on the roll of tape, this time with the right side facing up.
  3. Install the roll pin. Be sure the pin is installed with equal lengths on both sides.

Step 8:
Reassemble and test your Glock pistol and the newly installed Lever.




Installation - Complete

Other Worthwhile Modifications for Your Glock 19

  1. Glock Manual Safety/ Cominolli Safety

  2. Glock 3.5 LB Connector

  3. Glock 19 Mag Well (Magazine Well)

  4. Glock 19 Extended Slide Stop Lever

  5. Lone Wolf GESL01C Chrome Extended Side Stop Lever

  6. Glock 19 Extended Magazine Release

 

Comments & Questions

:
:

All comments are reviewed and posted manually. Your last name and email address will not be published. Submitting URLs & SPAM through this form is not permitted.